SW14USB 10Gbps USB 3.2 G2 Switcher FW Version: V1.2.0 ======================= System Information Commands ?/HELP Print Help Information REBOOT Reboot System STATUS Print System Status And Port Status FWVER Print All Firmware Version ======================= System Control Commands PON/OFF Set System Power On Or Off RESET Reset System To Default Setting RESET ALL Reset System And Network To Default Setting (Type "Yes" To Confirm, Or Send Other Command To Discard) SYSTEMLOG ON/OFF Enable Or Disable System Log Print AUTO STANDBY DLY xx Set Auto Standby Delay Time to xx min xx = 0-30 HOST yy FR All Set Connect From Host:yy yy = 01 : Host1 yy = 02 : Host2 yy = 03 : Host3 yy = 04 : Host4 SWITCH aa Set Switching To aa aa = AUTO: Auto Switching ON - Auto Mode aa = MAN: Auto Switching OFF - Manual Mode USBDP aa Set USB Device Power Mode aa = FH : Follow Host aa = ON : Always On USBDPOUT yy ON/OFF Set USB Device Power Output yy = 00 : All Devices yy = 01 : Device1 yy = 02 : Device2 yy = 03 : Device3 yy = 04 : Device4 CHARGE MODE aa Set USBC Charge Mode aa = 00 : Follow Host aa = 01 : Always Host 01 aa = 02 : Always Host 02 aa = 03 : Host 01 And Host 02 Equalization GPI ENABLE/DISABLE Set GPI Mode Enable Or Disable GPI yy Set GPI Mode yy = 00 : Pulse Mode yy = 01 : Level Mode yy = 02 : Contact Closure Mode GPI LOW xx Set The Low Level Voltage In The Level Mode xx Range 0~12000 Unit mV GPI HIGH xx Set The High Level Voltage In The Level Mode xx Range 0~12000 Unit mV KEY ON/OFF Set Key Control On Or Off HOST xx SPEED yy Set Host xx Port Speed xx = 03 : Host3 xx = 04 : Host4 yy = 00 : Speed 5Gbps yy = 01 : Speed 10Gbps DEVICE xx SPEED yy Set Device xx Port Speed xx = 03 : Device3 xx = 04 : Device4 yy = 00 : Speed 5Gbps yy = 01 : Speed 10Gbps ======================= RS232 Control Commands RSB x Set RS232 Baud Rate To x bps x = 0 115200, 1 57600 (Default), 2 38400, 3 19200, 4 9600, 5 4800, 6 2400 RS232SEND x:y:a Send y Type Of Command a Stored In Local RS232 Whose Baud Rate Is x x = 0 115200, 1 57600 (Default), 2 38400, 3 19200, 4 9600, 5 4800, 6 2400 y = a ASCII, h HEX a = RS232 Command ======================= Network Control Commands NET DHCP ON/OFF Set Auto IP(DHCP) On Or Off NET TN 8000 ON/OFF Set Telnet Port 8000 On Or Off NET TN ON/OFF Set Telnet Port On Or Off NET MDNS ON/OFF Set mDNS On Or Off NET MDNS xxxx.local Set mDNS Name to xxxx.local NET IP xxx.xxx.xxx.xxx Set IP Address NET GW xxx.xxx.xxx.xxx Set Gateway Address NET SM xxx.xxx.xxx.xxx Set Subnet Mask Address NET RB Set Network Reboot And Apply New Config!!! NET TN xxxx Set Telnet Port ================================================================